Juniper Networks 208, 5200, 204, 500 The DHCP IP Pool not in the same subnet with gateway/interface

Juniper Networks NetScreen Release Notes

•02551 – An NSRP backup device indicated that a failover occurred continuously when no failure on the primary device occurred.

•02543 – A device rebooted because of an improperly processed checksum.

•02542 – When upgrading a Juniper NetScreen-5GT from ScreenOS 4.0.0r4 to ScreenOS 5.0.0r3, a PPP connection from a Windows XP client to a Windows 2000 server stopped working.

•02536 – The priority value on a WebTrends syslog message varied from device to device.

•02531 – After changing manage options in the Untrust interface with a DHCP client configured, the device renewed its IP address with the DHCP server, causing loss of configuration of MIPS, DIPs, and VIPs.

•02509 – A memory leak in the NSRP synchronization process between two devices caused some FTP sessions to stop working.

•02477 – You cannot configure the NSRP Lite feature through the WebUI even though you applied an NS-5GT extended key.

•02457 – The URL request function that sent content to a WebSense server sometimes engaged the CPU on a device for too long causing the device to reboot.

•02403 – There was a flaw in the TCP stack buffer which caused the device to fail.

•02390 – When you created an aggregate interface on a Juniper NetScreen-5000 system, a CLI get command and an SNMP get operation indicated different bandwidth values for the interface. In some cases, the CLI command revealed 100 Mbps and the SNMP command revealed 0 MBps.

•02388 – You could not set the DHCP IP address range through the WebUI when detecting an auto-probe. By attempting to perform this operation, the system displayed the following message:

The DHCP IP Pool not in the same subnet with gateway/interface

•02372 – If you ran an OSPF virtual routing instance on a route-based VPN, under heavy traffic conditions, the device could continually spawn new sessions for the OSPF packets.

•02369 – You could not change the IKE Authentication user’s password when using the WebUI.

•02362 – In some instances, a TCP session prematurely expired.

•02344 – When you tried to bind a PKA key to an administrator account using the WebUI, the device generated a trace dump.

•02342 – An OpenSSH client continued to use password authentication even when password authentication was not an option for SSH.

•02335 – The SNMP iftype value was wrong on the Juniper NetScreen-5XP.

ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 19 of 42