SONET/SDH OC12c/STM4 PIC

SONET/SDH OC12c/STM4 PIC

Software release

JUNOS 8.0R2 and later

 

NOTE: This PIC is not supported in JUNOS Release 8.1R1.

Description

One OC12 port

 

Power requirement: 0.23 A @ 48 V (10.8 W)

Hardware features

Multiplexing and demultiplexing

 

Rate policing on input

 

Rate shaping on output

 

Packet buffering, Layer 2 parsing

Software features

SONET/SDH framing

 

Link aggregation

 

Alarm and event counting and detection

 

Dual-router automatic protection switching (APS)

 

Multiprotocol Label Switching (MPLS) fast reroute

 

Encapsulations:

 

 

High-Level Data Link Control (HDLC)

 

 

Frame Relay

 

 

Circuit cross-connect (CCC)

 

 

Translational cross-connect (TCC)

 

 

Point-to-Point Protocol (PPP)

Cables and connectors

Duplex SC/PC connector (Rx and Tx)

Optical interface support—See Table 28 on page 93

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links, take the PIC offline until you are ready to establish a link to another device. For information about taking a PIC offline, see the request chassis pic offline command in the JUNOS System Basics and Services Command Reference.

SONET/SDH OC12c/STM4 PIC 91

Page 91
Image 91
Juniper Networks M120 manual SONET/SDH OC12c/STM4 PIC