Juniper Networks M120 manual Optical Interface Support for ATM2 IQ OC48 PICs

Software features

Cables and connectors

LEDs

Alarms, errors, and events

ATM2 OC48/STM16 IQ PIC with SFP

■Multiprotocol Label Switching (MPLS) circuit cross-connect for leveraging ATM access networks

■User-configurable virtual circuit (VC) and virtual path (VP) support

■Support for idle cell or unassigned cell transmission

■OAM fault management processes alarm indication signal (AIS), remote defect indicator (RDI), and loop cells

■Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP

■Local and remote loopback

■ATM Inverse ARP, which enables routers to automatically learn the IP address of the router on the far end of an ATM PVC

■Simple Network Management Protocol (SNMP):

■Management Information Base (MIB) 2 (RFC 1213)

■ATM MIB (RFC 1695)

■SONET MIB

■Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR) traffic shaping

■Per-VC or per-VP traffic shaping

■Support for F4 OAM cells

■Support for 16-bit VCI range

■Duplex LC/PC connector (RX and TX)

One tricolor per port:

■Off—Not enabled

■Green—Online with no alarms or failures

■Amber—Online with alarms for remote failures

■Red—Active with a local alarm; router has detected a failure

■Alarm indication signal (AIS-L, AIS-P)

■Bit error rate signal degrade (BERR-SD), bit error rate signal fail (BERR-SF)

■Bit interleaved parity errors B1, B2, B3

■Errored seconds (ES-S, ES-L, ES-P), far-end bit errors REI-L, REI-P (CV-LFE, CV-PFE), far-end errored seconds (ES-LFE, ES-PFE), far-end severely errored seconds (SES-LFE, SES-PFE), far-end unavailable seconds (UAS-LFE, UAS-PFE)

■Loss of cell delineation (LOC), loss of frame (LOF), loss of pointer (LOP-P), loss of signal (LOS)

■Payload mismatch (PLM-P), payload unequipped (UNEQ-P)

■Remote defect indication (RDI-L, RDI-P)

■Severely errored framing (SEF), severely errored framing seconds (SEFS-S), severely errored seconds (SES-S, SES-L, SES-P), unavailable seconds (UAS-L, UAS-P)

Table 11: Optical Interface Support for ATM2 IQ OC48 PICs

PIC Type	Single-Mode Intermediate Reach
Optical interface	Single-mode
Transceiver type	SFP

ATM2 OC48/STM16 IQ PIC with SFP ■ 31