To remove the speaker grilles
The speaker grilles are removable.
Holes
Projections
Speaker grille
To remove the speaker grille, insert your fingers at the top
of the speaker grille, pull towards you. Then pull the bottom towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Connecting Other Equipment
You can connect both of the analog and digital equipment.
•DO NOT connect any equipment while the power is on.
•DO NOT plug in any equipment until all connections are complete.
English
OPTICAL DIGITAL | Protective plug | |
OUT | ||
|
Before connecting the other equipment, remove the protective plug from the terminal.
Audio equipment with
an optical digital input
To optical digital input
Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the OPTICAL DIGITAL OUT terminal.
To connect a TV set
You can connect a TV with a video input jack: used as a monitor for video CD playback.
|
|
| OPTICAL DIGITAL | |
| ANTENNA |
|
| OUT |
| AM EXT | R | L | |
|
| AM LOOP | ||
|
|
| AUX |
|
|
| FM 75 |
|
|
|
| COAXIAL |
|
|
Auxiliary Equipment |
|
|
|
|
To video input | TV |
|
|
|
| VOLTAGE |
| SPEAKERS RIGHT |
|
| SELECTOR |
| LEFT | |
| 230V |
|
|
|
| 220V |
|
| |
| 127V |
|
|
|
|
| 110V |
|
|
|
|
| SPEAKER |
|
|
|
| IMPEDANCE |
|
|
|
| MIN 6 |
|
To connect audio equipment
Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.
| R | L |
| AUX |
|
| R |
|
| L |
|
To audio output | L |
|
| Audio equipment |
|
| R |
|
For playing the other equipment through this unit,
connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).
To connect audio equipment with an optical digital input terminal
You can record CD sound onto the connected digital equipment.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.
VOLTAGE
SELECTOR
230V
127V |
|
110V | Voltage mark |
Use a screwdriver to rotate the voltage selector so the voltage number the voltage mark is pointing at is the same as the voltage where you are plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.
Now, you can plug the AC power cord.
•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.