JVC UX-L36V Common Operations, Setting the Clock, Setting the AM Tuner Interval Spacing, English

Models: UX-L46V-- Consists of CA-UXL46V and UX-L36V GVT0095-003A UX-L46V SP-UXL36V CA-UXL36V CA-UXL46V

1 36
Download 36 pages 50.12 Kb
Page 12
Image 12
Common Operations

English

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. When you plug the AC power cord into the wall outlet, “0:00” starts flashing on the display.

You can set the clock whether the unit is on or off.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1

Press CLOCK/TIMER.

CLOCK

/TIMER

The hour digits start flashing on the display.

CLOCK/TIMER

To adjust the clock again

1Make sure Setting the Clock (timer) indicator is not lit on the display.

If it is lit, press and hold CLOCK/TIMER until it goes off.

2Press CLOCK/TIMER repeatedly until the unit enters the clock setting mode (the hour digit start flashing on the display).

First time you press CLOCK/TIMER, the unit enters the timer setting mode.

See pages 28 and 29.

3Repeat steps 2 and 3 of the procedure of “Setting the Clock.”

4Press and hold CLOCK/TIMER again so that Press CLOCK/TIMER. (timer) indicator goes off from the display.

2 Press UP or DOWN to adjust the hour, then press CLOCK/TIMER.

The minute digits start flashing on the display.

DOWNUP

UP

PREV

NEXT

DOWN

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change it to 9 kHz or 10 kHz spacing only while the unit is on standby.

CLOCK

CLOCK/TIMER

/TIMER

 

3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER.

On the unit ONLY:

To select 10 kHz intervals, press

STANDBY/ON

while holding

¢ NEXT.

 

To select 9 kHz intervals, press

STANDBY/ON To adjust the clock again while holding PREV 4.

When you change the setting

DOWNUP

PREV

NEXT

STANDBY / ON

The preset stations are erased. You will need to preset the stations again. (See page 12 and 13.)

To check the clock time during play
On the remote control ONLY:

Press DISPLAY.

DISPLAY

 

• Each time you press the button, the source indication and the clock time alternate on the display.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

The clock may gain or lose 1 to 2 minutes per month If this happens, set the clock again.

– 9 –

Page 12
Image 12
JVC UX-L36V manual Common Operations, Setting the Clock, Setting the AM Tuner Interval Spacing, Press CLOCK/TIMER, English