JVC UX-L36V, CA-UXL46V Playing Back Tapes, Playing Back a Tape, Press 0 Push Open on the unit

REV.MODE

REV. MODE

English

Playing Back Tapes

You can play back type I, type II, and type IV tapes without changing any settings.

Playing Back a Tape

1 Press 0 PUSH OPEN on the unit.

0 OPENPUSH

2 Put a cassette in with the exposed part of the tape down.

To stop playing, press 7.

To fast-wind to the left or to the right, press ¢ NEXT or

PREV 4 while the tape is not running.

The tape direction indicator (3 or 2) starts flashing quickly on the display.

To remove the cassette, press 0 PUSH OPEN on the unit.

To play both sides—Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

Press REV.MODE.

• Each time you press the button, reverse mode changes as follows:

:	The deck automatically	On the unit
	stops after playing both
		(only for UX-L36V)
	sides of the tape. Stops
	when playback in the 2
	direction is finished.
:	The deck continues to play both sides of the
	tape until 7 is pressed.
:	The deck automatically stops after playing one
	side of the tape.

3 Press 0 PUSH OPEN again.

4 Press TAPE 2 3.	TAPE
The unit automatically turns on and the tape
starts playing. The tape direction indicator
(3 or 2) flashes slowly on the display.
• Each time you press the button, the tape	TAPE
direction changes.

3: plays the front side.

2 : plays the reverse side.

When the tape plays to the end, the deck automatically

stops if the reverse mode is set to or . (See “To play both sides—Reverse Mode.”)

The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

If no cassette is inserted

“NO TAPE” appears on the display.

– 23 –