JVC CA-UXL36V Listening to FM and AM Broadcasts, 12, Tuning in to a Station, Presetting Stations

Listening to FM and AM Broadcasts Continued

English

Tuning in to a Station

1 Press FM/AM to select the band. FM/AM

The unit automatically turns on and tunes in to the previously received station (either FM or AM).

• Each time you press the button, the band

Presetting Stations

You can preset 30 FM and 15 AM stations—using either

automatic presetting or manual presetting.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction.

You can preset the stations you want into memory by

alternates between FM and AM.

FM/AM

following the presetting method.

To preset stations automatically—Automatic Presetting

You need to preset stations separately for the FM and AM

2 Press and hold PREV ¢ or		PREV	NEXT
4 NEXT for more than 1
second.
The unit starts searching for	DOWN		UP
stations and stops when a	PREV		NEXT
station of sufficient signal

strength is tuned in.

If a program is broadcast in

stereo, the ST (stereo) indicator lights up.

To stop searching, press ¢ NEXT or PREV 4.

When you press NEXT ¢ or PREV 4 briefly and

bands.

On the remote control ONLY:

1 Press FM/AM to select the band you	FM/AM
want to preset.

2	Press and hold AUTO PRESET for	AUTO
		PRESET
	more than 2 seconds.
	Local stations with strong signals are searched
	and stored in memory automatically.
	When automatic presetting is over, the station

repeatedly

The frequency changes step by step.

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive or noisy, press FM MODE so that the MONO indicator lights up on the display. Reception improves.

MONO

FM MODE

stored in preset number 1 is received.

3 Repeat steps 1 and 2 to store stations for the other band.

•When you cannot automatically store stations you want Stations with weak signals cannot be detected with this automatic presetting. To store such a station, use the manual presetting.

•When you unplug the AC power cord or if a power failure occurs

Preset stations with the automatic presetting are erased at once. If this happens, preset the stations again.

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcasted.

– 12 –