![](/images/new-backgrounds/1195672/19567265x1.webp)
Replacing the Light-Source Lamp
The
Replacing the
■Be sure that the power cord is unplugged from the wall outlet.
When the
The LAMP indicator and the message on the screen warn you that replacement of the lamp is required,
as follows:
1 Remove the lamp-replacement opening
Accumulated used hours of the
900 hours
1000 hours
•The LAMP indicator lights up on the projector.
•On the screen, “Lamp replacement” appears in red. To cancel this message, press the ESCAPE button.
•Arrange for a new
source lamp a little earlier.
* Every time the projector is turned on, the message appears.
•The LAMP indicator blinks on the projector.
•On the screen, “Warning Lamp replacement” appears in red and the word “Warning” blinks.
Replace the
To cancel this message, press the ESCAPE button. However, the same message will appear every one hour.
*Only OPERATE button to stop the projector and the ESCAPE button are operative.
*Once the projector is turned off, the projector does not turn on unless the
Lamp replacement
ESCAPE
Warning
Lamp replacement
ESCAPE
cover by loosening screws.
Loosen the two screws with a
Screw
Note
•The screws are fitted so that they do not come off the lamp- replacement opening cover.
No.51781
| • The projector is forcibly shut off. | |
1010 hours | * The projector does not turn on unless the | |
replaced with new one. | ||
| ||
|
|
Purchase a new
CAUTIONS
Be careful not to damage the claw.
2 Loosen the screws, raise the handle, and pull out the
• If the projector is set up in a constricted place which is unsuitable for work, and if you perform replacement work there, this |
could cause injury. Move the projector to a place large enough for work, and then replace the |
• Use a genuine product for the |
Loosen the two screws with a
Note
Screw
Also, never use an old |
the projector to malfunction or broken pieces to injure you. |
• Do not replace the |
lamp is still high and could cause a burn. Allow a cooling period of one hour or more before performing replacement. |
• Before starting |
the wall outlet. If you perform the replacement work with the power cord connected, this could cause injury or electric shock. |
• The |
lamp. If anything is unclear, please consult your dealer. |
56
• The screws are fitted so that they do not come off the light- source lamp.
Handle
(To be continued on the next page)
57