JVC DLA-M2000LU manual Insert the new light-source lamp fully, Inside and fasten the screws

1-34

Replacing the Light-Source Lamp

3 Insert the new light-source lamp fully	Light-source lamp
inside and fasten the screws.
Fasten the two screws with a flat-end screwdriver.

Replacing the Light-Source Lamp

■Resetting the Lamp Use Time

After replacing with a new light-source lamp, reset the lamp-time counter inside the projector to clear the accumulated lamp time to zero (0). After resetting, a new count will start for the new light-source lamp.

DLA-M2000LU DLA-M2000LE

CAUTION

■Projector’s button

STANDBY indicator

1Turn on the MAIN POWER switch to go

into stand-by mode.

• Do not touch the glass surface of the light-source lamp

directly with your hand as well as staining it. If you touch

In stand-by mode, the STAND BY indicator on the projector lights up.

with a bare hand, oils and other substances on your hand
may adhere to the lamp, possibly preventing it from
performing as specified and therefore giving a shortened
lamp life, a darkened screen, etc. To handle a new light-
source lamp, hold it by the plastic part. Never touch the	Handle
metal part or the front glass surface.

Screw

4HIDE button

3ESCAPE button

STAND BY

LAMP TEMP

	OPERATE
HIDE
	PC
KEYSTONE	VOLUME
	VIDEO
PRESET	MENU
ESCAPE	ENTER

OPERATE indicator

1PC button

MENU button

2ENTER button

2Press the following buttons on the projector, sequentially.

1Momentary press the PC button.

2Momentary press the ENTER button.

3Momentary press the ESCAPE button.

4Press and hold the HIDE button for two

seconds or more.

* During this sequence, the STAND BY and OPERATE

indicators alternately blink about every approx. 3

4Replace the lamp-replacement opening

cover and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

CAUTIONS

Lamp-replacement opening cover

Cursor buttons 5/∞

seconds. After completion of the sequence, the

STAND BY indicator alone stays on.

* Buttons must be pressed within 2 seconds of the

previous button.

* When you make a mistake in button operations, return

to the beginning of the sequence.

* To check the lamp time on the menu, press the MENU button

and select “Information” with the cursor button 5 or ∞.

The lamp use time is indicated in the item “Lamp time”.

Video main menu

No.51781

• Install the light-source lamp and close the lamp-replace- ment opening cover correctly; otherwise, a safety switch is activated to prevent the projector from operating.

•If the claw on the lamp-replacement opening cover is dam- aged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover.

5Reset the lamp use time.

Be careful not to damage the claw.

Menu
Image adj.	Input	VIDEO
Setting	Switcher	CH.0
Color temp.	Source	NTSC
Options
Language
	Lamp time	123 h
Information

Lamp time (0 h)

ENGLISH

Perform “Resetting the Lamp Use Time” on page 59.

PC main menu

Menu
Image adj.	Input	PC 1
Setting	Switcher	CH.0
Color temp.	Resolution 1280 1024
Options	Frequency H	79.9	kHz
Language	Frequency V	75	Hz
	Lamp time	123	h
Information

Lamp time (0 h)

FRANÇ AIS DEUTSH

58

CAUTION

•Reset the lamp use time only when you have replaced with a new light-source lamp. Never reset it during lamp life, otherwise the replacement time may become unclear, and lead to degraded performance or lamp explosion.

59

ESPAÑ OL ITALIANO