|
| Installing Batteries in the | ||||||||
Before | ||||||||||
Remote Control |
|
|
|
| ||||||
|
|
|
|
|
| |||||
You | Install two R6 (AA) batteries (supplied) into the | |||||||||
remote control, carefully match with the polarity | ||||||||||
Start | indicated inside the battery compartment. | |||||||||
1 | 2 |
|
| 3 | ||||||
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
Caution
•Incorrect use of batteries can result in hazards such as leakage and bursting.
•Do not mix new and old batteries together.
•Do not use different kinds of batteries together.
•Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.
•Remove batteries if the equipment will not be used for a month or more.
•When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.
•Do not recharge,
About the Remote Control
•Make sure there is no obstacle between the remote control and the remote control sensor on the unit.
•Use within the operating range and angle as shown.
Within about | DUBBING | ||
5 m |
|
|
|
|
| 60˚ | - |
|
|
| - |
| 1 |
|
|
4 |
| 2 |
|
7 | 5 | 3 |
|
86
0 9
Remote | Code (DVD): JVC C |
control | Code (VHS): JVC A |
•Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.
•Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.
•Replace the batteries when the operating range of the remote control reduces.
VCR / DVD Recorder Switching
Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [VCR/DVD] on the front panel.
|
| DUBBING |
|
VCR | PR | VCR/DVD | DVD |
| ||
VCR | DVD |
|
VCR/DVD
VCRDVD
DVD light
VCR light
VCR mode
Press [VCR] on the remote control. (Verify that the VCR light is lit.)
DVD mode
Press [DVD] on the remote control. (Verify that the DVD light is lit.)
Note
•Pressing only [VCR/DVD] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.
•Press [VCR/DVD] to select the DVD mode or the VCR mode.
•You cannot switch to the mode (DVD or VCR) that is in the
•If the media is available, you can start recording by pressing [DVD REC I] or [VCR REC I] on the remote control even if another equipment (DVD or VCR) is selected. In this case, the mode of the remote control will be automatically switched to the appropriate component.