JVC DR-MV2SEU Move, Auto Clock Setting, Setting the Clock, Press [SET UP] to exit, 3 Select “Channel” using, 7 Press [SET UP] to exit, 1 In stop mode, press [SET UP]

Move

You can replace two channels.

1 In stop mode, press [SET UP].

2 Select “Advanced Setting Menu” using [Cursor U / D], then press [ENTER].

If it has already appeared, proceed to step 3.

3 Select “Channel” using

[Cursor U / D], then press [ENTER].

4 Select “Move” using [Cursor U / D], then press [ENTER].

5 Select the position number of which you want to change the channel using [Cursor U / D], then press [ENTER].

You cannot select a position number where “– – –” appears next to the number, because “Skip” is set to “ON” for that position number.

6 Move the channel to another position number using

[Cursor U / D], then press [ENTER].

• To move another channel, repeat steps 5 to 6.

7 Press [SET UP] to exit.

Setting the Clock

Auto Clock Setting

Channel Tuning must be set before setting Auto Clock.

1 In stop mode, press [SET UP].

2 Select “Advanced Setting Menu” using [Cursor U / D], then press [ENTER].

If it has already appeared, proceed to step 3.

3 Select “Clock” using [Cursor U / D], then press [ENTER].

Advanced Setting Menu

Playback

Recording

Display

Select Video

Clock

Channel

Disc

Easy Setting Menu

4 Select “Auto Clock Setting” using [Cursor U / D], then press [ENTER].5 Select “ON” using [Cursor U / D], then press [ENTER].

The current time will be set automatically.

6	Press [SET UP] to exit.
7	Press [STANDBY/ON /I] to turn off.

The Auto clock function is activated.

This unit will search for the time only when the power is off. Leave the unit off for several minutes to give it time to set the clock.

Hint

•If you want to cancel “Auto Clock Setting,” select “OFF” using [Cursor U / D], and then press [ENTER] at step 5.

Note

•The default setting of “Auto Clock Setting” is “OFF.”

•The clock may set itself automatically after you connect the antenna cable to the unit and plug in the mains cable. In this case, the current time will appear on the front panel display.

•To set the clock automatically, the channel assigned to “P01” must receive the PDC signal.

•The clock cannot be set automatically if you are not receiving a channel in your area that carries a time signal. In this case, set the clock manually.

•Once the auto clock setting is performed, the unit will correct the current time by receiving PDC broadcasts whenever you turn off the unit.

•The unit will correct the current time automatically at 8:00, if the unit power is turned off.

•Between 23:00 and 1:00, the Auto Clock function will not operate even if the unit power is turned off.

Started Getting