JVC DT-E17L4G, DT-E21L4 Picture Sub Adjust, White Balance Setting, Remote Setting

Menu Configuration (cont.)

Picture Sub Adjust

Configure the standard level of image adjustment.

Item		To do	Setting value
Contrast*1		Adjust the standard level for the contrast adjusted with the CONTRAST knob on the front	–20 to +20
		panel.
Bright*1		Adjust the standard level for the brightness adjusted with the BRIGHT knob on the front	–20 to +20
		panel.
Chroma*1		Adjust the standard level for the chroma adjusted with the CHROMA knob on the front panel.	–20 to +20
Phase*1,*2		Adjust the standard level for the phase adjusted with the PHASE knob on the front panel.	–20 to +20
NTSC Setup		Select the set-up level of the input NTSC signal.	00 (compliant with 0 %
			set-up signal), 7.5 (compliant
			with 7.5 % set-up signal)
Component Level		Select the level of the analog component signal (480i and 576i only).	B75 (compliant with
			BetacamVTR 7.5 % set-up
			signal), B00 (compliant with
			BetacamVTR 0 % set-up
			signal), SMPTE (compliant
			with M2VTR signals)
sub menu		Display the sub menu which enables you to adjust the items in “Picture Sub Adjust” while viewing the actual picture.
reset		Restore the default settings for all the items in “Picture Sub Adjust”.
*1	Memorized for each input.
*2	When “Component Phase” is set to “Disable,” “Phase” cannot be adjusted if no NTSC signal is input.

White Balance Setting

Display the color temperature, and adjusts the drive level and cutoff point of each color (R/G/B).

Item	To do	Setting value
Color Temperature	Select the color temperature. (Cannot be set/changed)	9300K, 6500K, User
R Drive *1	Adjust the drive level of each color (red, green, and blue).	Min – 000 – Max
G Drive	● The maximum (Max) and minimum (Min) values vary depending on the input signal or	(in 1024 grades)
B Drive	other settings.
R Cut Off *1	Adjust the cutoff point of each color (red, green, and blue).	Min – 000 – Max
G Cut Off	● The maximum (Max) and minimum (Min) values vary depending on the input signal or	(in 1024 grades)
B Cut Off	other settings.
sub menu	Display the sub menu which enables you to adjust the items in “White Balance Setting” while viewing the actual picture.
reset	Restore the default settings for all the items in “White Balance Setting”.

*1 Memorized for each color temperature.

Remote Setting

Settings for the external control.

Item	To do	Setting value
Serial Type	Select a terminal for external control in serial mode.	RS232C, RS485
Parallel Type	Select a control method of the MAKE/TRIGGER terminal.	Make, Trigger, Set
Pin1
Pin2	Assign the control functions to the pins of the MAKE/TRIGGER terminal.	☞ "Display" in "Functions
Pin3	• Assign a function to each pin terminal by selecting “Set” in “Parallel Type” mentioned	controlled by the Make/
Pin4	above.	Trigger system" on page 23
Pin5
Pin6	The functions are assigned for “Pin6” – “Pin8” and you cannot change the assignment of	Tally
Pin7	these functions.	Enable
Pin8		GND

18