•When connecting the speaker cords, match their polarity with that of the speaker terminals: red/white to (+) and black to
1 | 2 |
3 4
From right front main speaker
From left front main speaker
Holes
Projection
Speaker grille
¤Powered subwooferFrom the powered subwoofer (not supplied)
#To adjust the voltage selectorEnglish
From right matrix | From left matrix |
surround speaker | surround speaker |
•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the System.
•The front main speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.
–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main power switch again.
Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV.
•DO NOT connect more than one speaker to each terminal.
•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.
Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing to the same voltage as where you are plugging in the unit. (See also the back cover page.)
Voltage mark
DO NOT plug in before setting the voltage selector and all connection procedures are completed.
Preparing the remote control
| When using the remote |
| control, point the top of the |
| remote control toward the |
| remote sensor as directly as |
| possible. If you operate it |
| from a diagonal position, |
| the operating range (approx. |
5 m) may be shorter. | |
|
•Dispose of batteries in the proper manner, according to federal, state, and local regulations.
DO NOT recharge, short, disassemble, heat the battery or dispose of it in a fire.
5