JVC GR-D790U manual Basic Recording, EN Video Recording, Tape Remaining Time, Quick Review

18 EN VIDEO RECORDING

	Basic Recording	● When a blank portion is left between recorded
		scenes on the tape, the time code is interrupted
		and errors may occur when editing the tape. To
NOTE:
		avoid this, refer to “Recording From The Middle
Before continuing, perform the procedures listed		Of A Tape” ( pg. 20).
below:		● To record in LP (Long Play) mode, pg. 33.

●Power (
pg. 13)

● Loading A Cassette ( pg. 16)	Tape Remaining Time
● Remove the lens cap. ( pg. 12)	Approximate tape
● Open the LCD monitor fully.
	remaining time appears on
● Select videos at 4:3 size or 16:9 (wide) size.	the display. “– – – min”
( pg. 17)	means the camcorder is
VIDEO/MEMORY	calculating the remaining
	time. When the remaining time reaches
	2 minutes, the indication starts blinking.
Zoom Lever	● The time required to calculate and display the
	remaining tape length, and the accuracy of the
	calculation, may vary according to the type of
	tape used.

Lock Button

Recording Start/Stop

Button

1 Set the VIDEO/MEMORY Switch to “VIDEO”.

2 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.

3 Press START/STOP button to start recording. “REC” appears on the display while recording is in progress. To stop recording Press START/STOP again.

Approximate recording time

Quick Review

Enables to check the end of the last recording. 1) Press QUICK REVIEW during the Recording-Standby mode. 2) Tape is rewound for about several seconds and played back automatically, then pauses in the Recording-Standby mode for the next shot.

●Distortion may occur at start of playback. This is normal.

●Slide the Power Zoom lever repeatedly to change the sound setting to on/off.

Tape	Recording mode
	SP	LP
30 min.	30 min.	45 min.
60 min.	60 min.	90 min.
80 min.	80 min.	120 min.

NOTES:

●If the Record-Standby mode continues for

5 minutes and no operation is performed, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor.