20 EN VIDEO RECORDING
Time Code | Recording From The Middle Of A Tape |
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
Display
Minutes
1)Play back a tape or use Blank Search
( pg. 22) to find the spot at which you want to start recording, then engage the Still Playback mode. ( pg. 21)
2)Set the Power Switch to “REC” while pressing down the Lock Button located on the switch, then start recording.
|
|
| Seconds |
|
|
| |
|
|
| Frames* |
|
|
| (30 frames = |
12 : 34 : 24 | 1 second) | ||
* Frames are not displayed during recording.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform Recording From The Middle Of A Tape ( pg. 20) in the following cases;
●When shooting again after playing back a recorded tape.
●When power shuts off during shooting.
●When a tape is removed and
●When shooting using a partially recorded tape.
●When shooting on a blank portion located partway through the tape.
●When shooting again after shooting a scene then opening/closing the cassette holder cover.
Dual Rec.
You can capture still images without disturbing the recording in progress. Press SNAPSHOT. A sub screen will be displayed for approx. 6 seconds to show you the snapshot image.
●The Still image is saved into the memory card while video is recorded onto the cassette tape.
●“REC SELECT” must be set to “
(CARD)” only.
Auto/Manual Mode
Press AUTO button repeatedly to switch to auto/manual recording mode. When manual mode is selected, the indicator “M” appears on the LCD monitor.
Auto Mode : A
You can record using no special effects or manual adjustments.
Manual Mode : M
Manual recording is possible by setting various functions.
AUTO 
MANUAL
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON”. ( pg. 34)
