![](/images/new-backgrounds/1288788/288788141x1.webp)
EN
71
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and
NOTES:
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections (☞ pg. 58)
6w
Remote sensor
TC 12 : 34
Lock button
|
| P |
|
| L |
|
| A |
|
| Y |
5S | M | AOFF |
|
|
Power Dial
RM-V711U (provided)
START/STOP
T W
DISPLAY
INSERT
PLAY |
PAUSE |
REW(IND) |
1 FIND EDIT OUT POINT
Playback the tape to locate the point where you want to stop editing. Confirm the time code at this point (☞ pg. 57).
2 FIND EDIT IN POINT
Press REW until the point is located, then press
PAUSE.
3 PREPARE FOR INSERT EDITING Press and hold INSERT on the remote control, then press PAUSE. “6w” and the Time Code (min.:sec.) appear and the camcorder enters
4 START RECORDING
Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in step 1.
5 PAUSE DURING EDITING
Press START/STOP. The camcorder
6 STOP EDITING
Press STOP while the camcorder is in the
NOTES:
●P.AE/Effects (☞ pg. 44) can be used to spice up the scenes being edited during Insert Editing.
●To display the Time Code during Insert Editing, ☞ pg. 56.
●When performing Insert Editing, the tape’s Video Area and
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops and “ERROR! REFER MANUAL” appears.