JVC GR-DLS1 manual 70 EN, Audio Dubbing

70EN

EDITING(Cont.)

Audio Dubbing

The audio track can be customized only when recorded on the 32 kHz mode (☞ pg. 37).

NOTES:

●Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching in the television, make connections (☞ pg. 58).

6e

Audio Dub Standby Power Dial

AV OUT (headphones) connector

Speaker

RM-V711U (provided)

T W

Remote sensor

External microphone

input connector (Located beneath the cover.)

Stereo microphone

DISPLAY

AUDIO MONITOR

A.DUB

PLAY PAUSE STOP

1 FIND EDIT-IN POINT

Play back the tape to locate the point where editing will start, then press PAUSE.

2 ENGAGE AUDIO DUB STANDBY While holding A. DUB on the remote control, press PAUSE. “6e” appears.

NOTES:

3 BEGIN DUBBING

Press PLAY, then begin “narrating”.

•Speak into the microphone.

4 PAUSE DURING DUBBING

Press PAUSE.

5 STOP DUBBING

Press STOP.

●Audio dubbing is possible using an optional microphone connected to the external microphone input connector (MIC).

●While an optional microphone is connected, the built-in microphone is disabled.

●When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.

●To select the desired sound for playback, press AUDIO MONITOR on the remote control.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones to the AV OUT (headphones) connector.

●If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 48 kHz recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.

RECORDING SOUND	DISPLAY	OUTPUT SOUND
32 kHz	FULL SOUND	Original and new tracks are combined and output in stereo.
	SOUND 2	New track is output on both “L” and “R” channels in stereo.
	SOUND 1	Original track is output on both “L” and “R” channels in stereo.