JVC GR-DVF20, LYT0244-001A manual 62 EN, Open the lens cover pg Close the LCD monitor

62EN

TROUBLESHOOTING(cont.)

	SYMPTOM		POSSIBLE CAUSES
34.	The LCD monitor	34.	•During playback of the
	indications are distorted.		unrecorded portion, High-
			speed Search and still
			playback, LCD monitor
			indications appear distorted.
			This is not a defect.
35.	An unusual mark appears.	35.
			————
36.	An error indication	36.	•A malfunction of some kind
	(E01 — E06) appears.		has occurred. In this case
			the camcorder’s functions
			become unusable.

37. The charge indicator on	37. •The temperature of the
the AC Power Adapter/	battery is extremely high/low.
Charger does not light.	•Charging is difficult in
	places subject to extremely
	high/low temperatures.
38. The recording mode	38. •This occurs when recording
indicator “LP” blinks.	in the LP mode is not
	available. After the indicator
	blinks, the recording mode
	switches to “SP” and
	recording goes on.
39. Picture does not appear on	39. •The lens cover is closed.
the LCD monitor.	•The LCD monitor is not
	open at an angle of over 45
	degrees.
	•The LCD monitor's
	brightness setting is too
	dark.
40. Picture does not appear in	40. •The lens cover is closed.
the viewfinder.	•The LCD monitor is open.
	•If the LCD monitor is not
	tilted upward to an angle of
	over approx. 105 degrees,
	Interface Shooting will not
	be possible.
41. When the image is printed	41. •This is not a malfunction.
from the printer, a black
bar appears at the bottom
of the screen.

42.The power lamp blinks. 42. •The camcorder was turned on when the battery power was almost gone.

CORRECTIVE ACTION

34.

————

35.•Check the section of the manual that explains LCD

monitor/viewfinder indications (☞ pg. 66, 67).

36.•Remove the power supply (battery pack, etc.), clock battery and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer.

37.•To protect the battery, it is recommended to charge it in places with a temperature

of 10°C to 35°C (50°F to 95°F) (☞ pg. 69).

38.

————

39.•Open the lens cover

(☞ pg. 16).

•Open the LCD monitor to an angle of over 45 degrees.

•Adjust the brightness of the LCD monitor (☞ pg. 19).

•If the monitor is tilted upward to 180 degrees, open the monitor fully (☞ pg. 19).

40.•Open the lens cover (☞ pg. 16).

•Close the LCD monitor.

•Open the LCD monitor and tilt it upward 180 degrees so

that it faces forward (☞ pg. 19).

41.•By recording with Picture

Stabilizer activated

(☞ pg. 20) this can be avoided.

42.•Replace with a charged battery pack (☞ pg. 8).