70 EN
Main Unit
1.For safety, DO NOT . . .
....open the camcorder’s chassis.
....disassemble or modify the unit.
....short-circuit the terminals of the battery pack. Keep it
away from metallic objects when not in use.
....allow inflammables, water or metallic objects to
enter the unit.
....remove the battery pack or disconnect the power
supply while the power is on.
....leave the battery pack attached when the
camcorder is not in use.
2.Avoid using the unit . . .
....in places subject to excessive humidity or dust.
....in places subject to soot or steam such as near a
cooking stove.
....in places subject to excessive shock or vibration.
....near a television set.
....near appliances generating strong magnetic or electric
fields (speakers, broadcasting antennas, etc.).
....in places subject to extremely high (over 40°C or
104°F) or extremely low (under 0°C or 32°F)
temperatures.
3.DO NOT leave the unit . . .
....in places of over 50°C (122°F).
....in places where humidity is extremely low. (below
35%) or extremely high (above 80%).
....in direct sunlight.
....in a closed car in summer.
....near a heater.
4.To protect the unit, DO NOT . . .
....allow it to become wet.
....drop the unit or strike it against hard objects.
....subject it to shock or excessive vibration during
transportation.
....keep the lens directed at extremely bright objects
for long periods.
....direct the eyepiece of the viewfinder at the sun.
....carry it by holding the viewfinder or the LCD
monitor. Be sure to hold the main unit with both
hands or use the grip.
....swing it excessively when using the shoulder strap.
5.Dirty heads can cause the following problems:
•No picture and sound during playback (blue back
screen).
•Blocks of noise appear during playback.
•During recording, the Head Clog Warning
indicator “ ” appears.
In such cases, use the optional Cleaning Cassette.
Insert it and play back. If the cassette is used more
than once consecutively, damage to the video heads
may result. After the camcorder plays back for about
20 seconds, it stops automatically. Also refer to the
Cleaning Cassette’s instructions.
If, after using the Cleaning Cassette, the problems
still exist, consult your nearest JVC dealer.
Mechanical moving parts used to move the video
heads and video tape tend to become dirty and worn
out over time. In order to maintain a clear picture at
all times, periodic check-ups are recommended after
using the unit for about 1,000 hours. For periodic
check-ups please consult your nearest JVC dealer.
LCD Monitor
1.To prevent damage to the LCD monitor,
DO NOT . . .
....push it strongly or apply any shocks.
....place the camcorder with the LCD monitor on the
bottom.
2.To prolong service life . . .
....avoid rubbing it with coarse cloth.
3.Be aware of the following phenomena for LCD
monitor use. These are not malfunctions . . .
•While using the camcorder, the surface around the
LCD monitor and/or the back of the LCD monitor may
heat up.
•If you leave power on for a long time, the surface
around the LCD monitor becomes hot.
CAUTIONS (cont.)
About moisture condensation . . .
●You may have observed that pouring a cold liquid
into a glass will cause drops of water to form on
the glass’ outer surface. This same phenomenon
occurs on the head drum of a camcorder when it
is moved from a cool place to a warm place, after
heating a cold room, under extremely humid
conditions or in a place directly subjected to the
cool air from an air conditioner.
●Moisture on the head drum can cause severe
damage to the video tape, and can lead to
internal damage to the camcorder itself.
Serious malfunctioning
If malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.