Tape remaining time indicator
25 min 
min
(Now calculating)
90min
89min
3min
2min
(Blinking)
1min
(Blinking)
0min
(Blinking)
Recording Start/Stop Button
DISPLAY
EN17
4 |
| STOP RECORDING |
|
| |
| Press the Recording Start/Stop Button again to stop |
| |||
|
| recording. |
| ||
|
|
|
|
| |
|
| •The camcorder |
| ||
NOTES: |
| ||||
● When the Power Switch is set to “CAMERA” and the |
| ||||
LCD monitor is opened at an angle of 45 degrees or |
| ||||
more, the LCD monitor switches on and the viewfinder |
| ||||
switches off automatically to save power. |
| ||||
● A cassette holder cannot be opened unless a power |
| ||||
supply is attached. |
| ||||
● There may be a delay after you open the cassette cover |
| ||||
until the holder opens. Do not use force. |
| ||||
● The tape remaining time is only displayed in the |
| ||||
viewfinder as shown. |
| ||||
● The remaining time indicated in the viewfinder is |
| ||||
approximate. |
| ||||
● The time required to calculate the remaining tape |
| ||||
length, and the accuracy of the calculation, may vary |
| ||||
| |||||
according to the type of tape used. |
| ||||
● “TAPE END” appears when the tape reaches its end, and | RECORDING | ||||
the power goes off automatically if left in this condition | |||||
| |||||
for 5 minutes. “TAPE END” also appears when a cassette |
| ||||
whose tape is already at its end is loaded. |
| ||||
● If the |
| ||||
camcorder’s power shuts off automatically. Set the |
| ||||
Power Switch to “POWER OFF”, and then back to |
| ||||
“CAMERA” to turn the camcorder on again. |
| ||||
● When a blank portion is left between recorded scenes |
| ||||
on the tape, the time code is interrupted and errors may |
| ||||
occur when editing the tape. Continue recording from |
| ||||
where you stop so that there are no gaps by following |
| ||||
“Recording from the middle of a tape” (☞ pg. 22). |
| ||||
● The LENS COVER warning blinks for about 5 seconds |
| ||||
when the camcorder is turned on with the cover closed. |
| ||||
● While shooting, sound is not heard from the speaker. |
| ||||
LCD Monitor/Viewfinder Indications |
| ||||
You can make the LCD monitor/Viewfinder indications |
| ||||
appear/disappear. |
| ||||
|
|
|
|
| |
1 |
| PRESS DISPLAY BUTTON |
| ||
| When you do not want the indications to appear, |
| |||
|
| press DISPLAY for longer than approximately 1 |
| ||
|
| second. Certain indications disappear. |
| ||
|
| Press again for longer than approx. 1 second to make |
| ||
|
| the indicaitons reappear. |
| ||
NOTE: |
| ||||
It is impossible to make the tape running indicator “444” |
| ||||
and warnings etc. disappear from the LCD monitor or the |
| ||||
viewfinder. For the indications that can be removed, |
| ||||
☞ pg. 66 and 67. |
| ||||
