JVC GR-DVX90 specifications 62 EN, Optional, Play Stop

Make sure the camcorder’s power is off.

62 EN

POWER Switch

Lock Button

Open the connector cover.

To DV

IN/OUT

	Core filter
	DV cable
	(optional)
	Core filter
To DV IN	Video unit equipped
	with DV connector

PLAY (4)

STOP (5)

DUBBING (cont.)

Dubbing To A Video Unit Equipped With A DV Connector (Digital Dubbing)

It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

[To use this camcorder as a player]

1

2 Connect the camcorder to your video unit equipped with a DV connector using a DV cable as shown in the illustration.

3 Set the camcorder’s POWER Switch to “” while pressing down the Lock Button located on the switch. Press 4to play back the source tape.

4 While watching the playback on the monitor, engage the DV connector-equipped video unit’s record mode from the spot on the source tape you want to begin recording.

NOTES:

●It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the battery pack (
pg. 7).

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●For Digital Dubbing, this camcorder can be connected only to one device at a time.

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 3. If this occurs, turn off the power and make connections again.

●If “Playback Zoom” (
pg. 68), “Playback Special Effects” (
pg. 69) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV OUT connector.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.