Masterpage:Right-NoTitle0
EN 85
Filename [HM-HDS4EX_07Sub.fm]
Page 85 April 2, 2003 3:11 pm

SHOWVIEW® System Setup

Guide Program Number Set

AAccess the Main Menu screen.
Press MENU.
BAccess the Initial Set screen.
APress w e to move the arrow to “INITIAL SET UP”,
then press t.
BPress w e to move the arrow to “INITIAL SET”, then
press OK.
CAccess the Guide Program Set screen.
Press rt to move the highlight bar (pointer) to “GUIDE
PROG SET”, then press OK or e.
DEnter the Guide Program number.
Press rt to enter the Guide
Program number for the desired
station as shown in the TV
listings. Then press OK or e.
EEnter the receiving channel position number.
FReturn to the normal screen.
Press MENU.
IMPORTANT
Normally, Auto Set Up (墌pg. 14), Preset Download (墌pg. 16) or Auto Channel Set (墌pg. 88) sets the Guide Program numbers
automatically. You need to set the Guide Program numbers manually only in the following cases.
●When timer-programming with the SHOWVIEW system, the channel position, where the station you wish to record is received on
your recorder, is not selected,
OR
when you add a channel after Auto Set Up, Preset Download or Auto Channel Set has taken place,
—Set the Guide Program number for that station manually.
●When you wish to timer-record a satellite programme with the SHOWVIEW system,
—Set the Guide Program numbers for all satellite broadcasts received on your satellite receiver.
●Turn on the TV and select the AV mode.
●Slide TV/CABLE/SAT switch to the right.
(Example) When inputting the
Guide Program
number 2 for ZDF.
Press the number key “0” to
select “TV PROG” or “SAT”.
Then press rt to input the
number of the recorder’s
channel position on which the
Guide Program number’s
broadcast is received by the
recorder or the satellite
receiver. Then press OK or e.
●To timer-record a satellite
programme with the SHOWVIEW
system, you need to install the
provided Satellite Controller and
perform the procedure described
in “Satellite Receiver Control
Setting” (墌pg. 19).
●Repeat steps D and E as
necessary.
(Example) If ZDF is received on
channel position 2.

Guide Program Number

“Guide Program (GUIDE PROG) number” refers to the
assigned TV station numbers, according to broadcast area,
for the SHOWVIEW timer recording. The Guide Program
numbers can be found in most TV listings.
HM-HDS4EX.book Page 85 Wednesday, April 2, 2003 3:55 PM