JVC HR-S4800U manual Cable Box Control Setting, Situate Controller, Attach Controller

Controller (suggested locations)

Cable box

EN 15

Cable Box

Control

Setting

Suggested location

Place the cable box on top of the VCR. Attach the VCR’s Controller to the top of the VCR with the Controller’s transmitter pointed towards the cable box’s remote sensor.

ATTENTION:

The Controller can also control a DBS receiver. If both a cable box and a DBS receiver are used, position the Controller so its signal reaches the remote sensors on both the cable box and DBS receiver.

Your VCR

Cablebox

To	To
RF output	Audio/Video
Controller	output
Transmitter	or
To	To
ANTENNA	AUDIO/
IN	VIDEO IN

Your VCR

CABLE

BOX

The following procedure is required if you receive your TV channels through a cable box (descrambler). The Controller allows the VCR to automatically switch the cable box channel during timer recording. The Controller is effective for recording broadcasts that have been programmed using VCR Plus+ (Z pg. 30) or Express timer programing (Z pg. 34).

NOTE:

ONLY FOR HR-S3800U: The Controller is not supplied with this unit. It can be requested by mailing in the completed JVC Cable Mouse Certificate that is included with the accessory package.

Installing Controller

1	Situate Controller
	Place the Controller so that its transmitter is
	facing the cable box’s remote sensor.
	c Make sure the path between the Controller and
	the cable box’s remote sensor is not blocked.

2		Attach Controller
		Fix securely using the adhesive strip attached on
		the back of the Controller.
3
		Connect cable box to VCR
		c If yourcableboxdoesnothaveaudio/video
		outputconnectors
		Connect the RF output terminal on the cable
		box to the ANTENNA IN terminal on the rear of
		your VCR.
		c If your cable box has audio/video output
		connectors
		Connect an audio/video cable between the
		AUDIO/VIDEO IN connectors on the rear of
		the VCR and the audio/video output connectors
		on the cable box.
		NOTE:
		When connecting your cable box, refer to its instruction
	manual.
4
		Connect Controller to VCR
		Connect the Controller to the CABLE BOX

Controller connector on the rear panel.

How to control the cable box

This VCR has two separate methods to control your cable box.

c The VCR’s wireless Remote can control your cable box. This eliminates the need for a separate cable box’s Remote.

cThe VCR’s Controller can also control your cable box. This allows the VCR to change your cable box’s channel number during timer recording.

Each method must be set up separately. To set up the VCR’s Remote, refer to page 51. To set up the Controller, go to page 16.

HR-S4800U/S3800U-EN01-20 15 00.1.31, 9:55 AM