BASIC PLAYBACK AND RECORDING | EN 21 |
Basic
Playback
Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.
| 2 | SHUTTLE |
POWER | ring |
| REW |
POWER | MENU |
PLAY
VIDEO |
SP | EP | CH |
|
| |
| VCR | REC | STOP/EJECT PAUSE |
OK
STOP/EJECT
( 7/ 0)
POWER
1 2 3
2
4 5 6
7 8 9
0 4
This VCR can check the tape condition during playback (and recording), and realizes the best possible pictures.
1 | Load a cassette |
Make sure the window side is up, the rear label | |
| side is facing you and the arrow on the front of |
| the cassette is pointing towards the VCR. |
| Do not apply too much pressure when inserting. |
|
|
| c The VCR turns on automatically. |
| c The counter is automatically reset to “0:00:00”. |
| c If the cassette’s record safety tab has been |
| removed, playback begins automatically. |
2 | Start playback |
Press PLAY ( 3 ). |
c Tape speed (SP or EP) is automatically detected. c The
VHS ET mode (Z pg. 27)
c If “VIDEO CALIBRATION” is set to “ON” (default setting: Z pg. 39), “VIDEO CALIBRATION” appears on the screen, and this VCR checks the tape condition during automatic tracking.
To stop playback
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 ) on the front panel.
To rewind the tape
Press REW ( 1 ) (or turn the SHUTTLE ring on the front panel to the left).
To
Press FF ( ` ) (or turn the SHUTTLE ring on the front panel to the right).
2
REW ( 1)
1
FF ( ` )
STOP ( 7 )
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the tape is not running.
c You can also eject the cassette with the VCR turned off.
To turn off the VCR
Press POWER.
Clean the video heads using a dry cleaning cassette —
•Rough, poor picture appears while a tape is played back.
•The picture is unclear or no picture appears.
•“USE CLEANING CASSETTE” appears on the screen (only with “SUPERIMPOSE” set to “ON”: Z pg. 38, 39.)
21 | 00.1.31, 9:57 AM |
