JVC HR-S5700AM Timer Programming, Access G-CODE Showview Screen, Enter G-CODE Number

26ENTIMERRECORDING (cont.)

G-CODE™/SHOWVIEW™

Timer Programming

Remember, the clock must be set before you can programme the timer ( pg. 10).

INFORMATION

G-CODEand SHOWVIEW are different trademarks used to represent the same easy recording feature, but only the term G-CODEsystem will be used in the instructions. If you use the SHOWVIEW system, follow the same instructions listed for the G-CODEsystem.

Before performing G-CODE/SHOWVIEWTimer Programming:

●Be sure to read "G-CODE/SHOWVIEWSystem Setup" ( pg. 24).

●Insert a cassette with the safety tab in place. The recorder will come on automatically.

●Turn on the TV and select the VIDEO channel (or AV mode).

●Select the appropriate colour system by pressing the COLOUR SYSTEM button ( pg. 44).

	SYSTEM	PR+
		PR–
COLOUR

1 2 3

With the G-CODEsystem , timer programming is greatly simplified because each TV programme has a corresponding code number which your recorder is able to recognise.

ACCESS G-CODE/

SHOWVIEW SCREEN

1	Press PROG.	G-CODE/SHOWVIEW
		[0 – 9] =
		[+/–] : EXPRESS PROGRAMING
		[PROG] : EXIT
	ENTER G-CODE NUMBER
	Press the NUMBER keys to	G-CODE/SHOWVIEW
	enter the G-CODEnumber
2 of a programme you wish		1 2 3 4 5 6 7 8
	to record.
	● If you make a mistake,	[0 – 9] =
	press and input the	[ ] : DELETE
	correct number.	[PROG] : EXIT
	ACCESS G-CODE
	PROGRAMME SCREEN
	Press OK, and the G-CODE		– P1 –
	Programme screen	G-CODE/SHOWVIEW123456789
3 appears. (If you're just		START		STOP
		21:00 =		22:00
	starting out, "P1" appears.)			SP
		DATE		TV PROG
		25.04		1
		: OK

IMPORTANT

Make sure the channel position number you wish to record is displayed; if not, see "G-CODE/SHOWVIEWSystem Setup" on page 24 and set the Guide Program number for that G-CODEnumber correctly.

● If the number you entered is invalid, "ERROR" appears

on the screen. Press and input a valid G-CODE

number.

● If the "G-CODE/SHOWVIEW SETUP" screen appears,

4 5 6

7 8 9

2NUMBER

see "ATTENTION – Regarding Guide Program

Number Set" on page 27.

SET TAPE SPEED

4

0

4 Press SP/LP/EP () to set the tape speed.

1

PROG

SP/LP/EP

3

OK