JVC HR-VP434U manual Basic Connections

6INSTALLINGYOURNEWVCR

Basic Connections

Antenna or Cable

Coaxial Cable

	Flat Feeder
AC Power	Maching Transformer
Cord
Back of VCR	ANTENNA-IN	RF
AC Outlet	(Antenna or Cable input)	OUT

TV	RF Cable
	(provided)
	75 ohm terminal

Back of VCR

AUDIO

VIDEO

CH3 CH4

	CHECK CONTENTS
	Make sure the package contains all of the accessories
1 listed in “SPECIFICATIONS” (☞ pg. 52).
	SITUATE VCR
2 Place the VCR on a stable, horizontal surface.
3	CONNECT VCR TO TV
	The connection method you use depends on the type of
	TV you have.
	RF Connection
	● To Connect To A TV With NO AV Input Terminals . . .
	a– Disconnect the TV antenna from the TV.
	b– Connect the TV antenna cable to the ANT IN jack
	on the rear of the VCR.
	c– Connect the supplied RF cable between the RF
	OUT jack on the rear of the VCR and the TV’s
	antenna terminal.

AV Connection

●To Connect To A TV With AV Input Terminals . . .

a– Connect the antenna, VCR and TV as shown in the illustration.

b– Connect an Audio/Video Cable (not supplied) between the AUDIO OUT and VIDEO OUT jacks on the rear of the VCR and the AV IN jacks on the TV.

	CONNECT VCR TO
4	POWER SOURCE
	Connect the power plug to an AC outlet.
	● The clock will automatically be set when the antenna
	is connected and when the AC is first connected to
	the VCR (☞ pg. 7).
	FINAL PREPARATION FOR
5	USE
	Select the VCR channel (3 or 4) by setting the switch
	on the rear of the VCR as shown in the illustration.
	Turn on the power to the TV. You are now able to perform
	simple playback (☞ pg. 22) and recording (☞ pg. 23).
	(If 'Auto' is displayed on the front display panel, the
	clock is being set automatically. Wait for the time to be
	displayed before powering on the VCR.)

NOTES:

●The VCR channel is the channel on the TV which will display the audio and video signals from the VCR. The VCR's CH3- CH4 switch sets the VCR channel to CH3 or CH4.

●The CH3–CH4 switch is preset to the CH3 position. Set to CH4 if CH3 is used for broadcasting in your area.

●If your TV has no AV input terminals, set the channel on the TV to correspond to the CH3–CH4 switch on the back of the VCR.

●Even if your TV has AV input terminals, you must connect it to the VCR using an RF cable in order to record one show while watching another (☞ pg. 32).

●For full identification of the VCR's rear panel, refer to the Index (REAR VIEW ☞ pg. 50).