15

Basic Connections

Aerial connector

Back of TV

21-pin SCART

TV aerial

cable

connector

 

21-pin SCART

 

cable

RF cable

(not provided)

 

(provided)

Mains power cord

ANTENNA

 

IN

Back of unit

L-1 IN/OUT ANTENNA

OUT

Mains outlet

Make AV connection if your TV has a 21-pin AV input connector (SCART) in order to reduce the possibility of interference. With AV connection, you can enjoy stereo playback of video tapes if you are using a stereo TV.

In addition, if you connect the unit to the TV’s RGB connectors, set the output mode for the L-1 IN/OUT connector so that the RGB signal is output from the unit. When the DVD deck is selected, press and hold 8 until the desired mode appears on the front display panel.

yc: Select when your TV is compatible with the Y/C signal. Y/C signal is output from the unit. Also set “L-1 OUTPUT” to “S-VIDEO”. ( pg. 62)

rgb: Select when your TV is compatible with the RGB signal. RGB signal is output from the unit.

NOTES:

●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV’s SCART connector.

●For switching the TV’s mode, refer to the instruction manual of your television.

It’s essential that your unit be properly connected.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

A Situate the unit.

Place the unit on a stable, horizontal surface.

B Connect the unit to TV.

The connection method you use depends on the type of TV you have.

RF Connection8To connect to a TV with NO AV input connectors —

ADisconnect the TV aerial cable from the TV.

BConnect the TV aerial cable to the ANTENNA IN connector on the rear panel of the unit.

CConnect the provided RF cable between the ANTENNA OUT connector on the rear panel of the unit and the TV’s aerial connector.

AV Connection8To connect to a TV with AV input connectors —

AConnect the aerial, unit and TV as per “RF Connection”.

BConnect an optional 21-pin SCART cable between the L-1 IN/OUT connector on the rear panel of the unit and the TV’s 21-pin SCART connector.

CSet the output mode for the L-1 IN/OUT connector depending on type of your TV. ( left column)

C Connect the unit to mains.

Plug the end of the mains power cord into a mains outlet.

After the connection is completed, perform “Auto Set Up” on page 16.