83
Set station names other than the ones registered in your unit.
Perform steps A and B of “Manual Channel Set” on page 80 to access the Confirmation screen and then perform steps A and B of “Set Stations (A)” above before continuing.
A Select the character for station name.Press e until the first letter of the station name begins blinking.
Fine-Tuning Channels Already Stored
Perform steps A and B of “Manual Channel Set” on page 80 to access the Confirmation screen before continuing.
A Select the channel toPress rt w e until the channel you want to tune begins blinking.
B Access the Manual Channel Set screen.Press OK twice. The Manual Channel Set screen appears.
| C Perform tuning. | |
| Press e until | |
B Enter the new character. | the picture is its clearest. Then press OK. | |
● The Confirmation screen appears. | ||
Press rt to cycle through the characters | ||
D Close the Confirmation screen. | ||
f, +, I (space) ) and stop when the desired character is | ||
indicated, then press e to enter. Enter the remaining | ||
characters the same way (maximum of 4). After entering | Press SET UP MENU. | |
all characters, press OK. | ||
|
●The Confirmation screen appears.
●If you make a mistake, press w until the incorrect character begins blinking. Then enter the correct character by pressing rt.
C Close the Confirmation screen.
Press SET UP MENU.
NOTE:
The characters available for the station name (ID) are