27

Repeat Playback

Your unit can automatically play back the whole tape 100 times repeatedly.

1Start playback.

Press 4.

2Activate Repeat Playback.

Press 4 and hold for over 5 seconds, then release.

●The Play indicator ($) on the front display panel blinks slowly.

●After playing back a tape 100 times, the unit stops automatically.

3Stop Repeat Playback.

Press 8 at any time.

●Pressing 4, 3, 5 or 9 also stops Repeat Playback.

NOTE:

Repeat playback is not possible with a cassette recorded in EP mode.

Manual Tracking

Your unit is equipped with automatic tracking control. During playback, you can override this and adjust the tracking manually by pressing the PR buttons.

1Override automatic tracking.

During playback, press p on the remote control.

2Adjust the tracking manually.

Press PR + or – on the remote control.

●Press p again to return to automatic tracking.

NOTE:

When a new tape is inserted, the unit enters the automatic tracking mode automatically.

NTSC Playback

Your unit is equipped with NTSC circuitry that can play back NTSC tapes.

1Load a cassette.

Insert a cassette recorded in NTSC.

2Start playback.

Press 4.

●“NTSC]PAL” appears on the screen for about 5 seconds.

NOTES:

●Some TVs shrink the picture vertically and place black bars at the top and bottom of the screen. This is not a malfunction on the part of either the unit or the TV.

●The picture may roll up and down. This can be corrected using the V-HOLD control found on some TVs. (This cannot be corrected if the TV does not have a V-HOLD control.)

●The counter and tape remaining time readings will be incorrect.

●During search, still, or frame-by-frame playback, the picture will be distorted, and there may be a loss of colour.

●Depending on the type of TV, the top and bottom portions of superimposed displays may be cut off during NTSC playback.

Soundtrack Selection

Your unit is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.

During Playback

Pressing A.MONITOR changes the soundtrack as follows:

TRACKUSE

 

On-Screen Display

 

 

 

HI FI

 

L j h R

For Hi-Fi stereo tapes

 

 

HI FI

For main audio of Bilingual tapes

L j

 

 

 

HI FI

 

h R

For sub audio of Bilingual tapes

 

 

NORM

For audio-dubbed tapes

 

 

HI FI

For audio-dubbed tapes

NORM

 

 

 

NOTES:

●“HIFI L j h R” should normally be selected. In this mode, Hi-Fi stereo tapes are played back in stereo, and the normal audio track is played back automatically for tapes with only normal audio.

●For instructions on recording stereo and bilingual programmes, refer to page 30.

●“O.S.D.” must be set to “ON” or the on-screen displays will not appear. ( pg. 72)