ENGLISH

STOP

PLAY

4

Adjust the volume.

To drop the volume in a moment

Press ATT (STR) while listening to any source. “ATT” starts flashing on the display, and the volume level will drop in a moment.

To resume the previous volume level, press the button again.

Operating the receiver in the User Word mode

In the User Word mode, you can use 13 preset Operation Commands and 12 Access Commands.

To use these voice commands in the User Word mode, you have to do the following:

To use the Operation Commands;

1Select the User Word mode (Follow steps 1 to 4 on page 27.)

2Register your voice into each Operation Command (Follow steps 5 to 11 on pages 27 to 29.)

To use the Access Commands;

1Select the User Word mode (Follow step 1 on page 30.)

2Select an operation to preset into an Access Command (For operations you can store into the Access Commands, see page 30.)

3Register your voice into the Access Command (See pages 31 to 34.)

Registering your own voice for the Operation Commands

When shipped from the factory, the System recognizes and accepts the Operation Commands anyone speaks (in the Standard Word mode).

If you do not like this and want to make the System accept only your own voice as an Operation Command, you need to record your own voice (within 3 seconds long).

Before you start...

•Set “VOICE WORD” to “USER.”

Without setting it to “USER,” you cannot record your own voice.

•Notice the following;

–You can only use the Operation Command for which you have registered your voice.

–You can register any word you want; however, if it is too short (ex. “Pops”), the System may not recognize it correctly.

26