STOP

PLAY

To operate the system in the User Word mode

Make sure to set “VOICE WORD” to “USER” by following steps 1 to 4 on page 27. Then follow the procedure below.

1Press VOICE to turn on the receiver.

2Press VOICE again to activate the Voice Recognition System.

3Speak one of the Operation Commands or of the Access Commands you have stored to the microphone while “SPEAK” is flashing on the display.

•For example, to use Access Command number 14, speak “Jazz 89” (which you have registered previously.)

4Press + or – to adjust the volume.

To check the registered voice and stored operations

Follow the procedure below.

1Press and hold VOICE until one of the Access Commands appears on the display.

2Press + or – to confirm the command contents.

• Each time you press + or –, the commands appear on the display in sequence.

You can check the command contents on the display.

EXAMPLE: A station of 89.5 MHz is stored in the Access Command 14 (with sound mode — “SOFT”)

EXAMPLE: Disc no. 01 of the CD changer is stored in the Access Command 15 (without any sound mode)

The recorded voice is also reproduced.

If you want to check the recorded voice again

Press VOICE while the voice command number you want to confirm is selected.

3Press and hold VOICE again to finish the checking.

ENGLISH

35