Note:
●When the [FULL AUTO] switch on the camera recorder is set to AONB, the recording level cannot be adjusted with the [AUDIO LEVEL
Set the [AUDIO SELECT
When the [FULL AUTO] switch is set to AONB, mode switching with the [AUDIO SELECT
Memo:
●When [Audio] in the [Camera Function]B[FULL AUTO] menu is set to ASW SetB, you can switch the recording level mode with the [AUDIO SELECT
on the camera recorder even if the [FULL AUTO] switch is set to AONB. (A Page 75)
Audio Monitor During RecordingYou can check the input audio with the monitor speaker or earphones.
1 Select the channel to monitor with the [MONITOR SELECT] switch.
[BOTH] Mixes and outputs audio from both [INPUT1/INPUT2] terminals.
2 Adjust the volume of the monitor audio with the [MONITOR] adjustment knob.
Monitor
Speaker
[PHONES] Terminal
[MONITOR] Adjustment Knob
[MONITOR SELECT] Switch
Memo:
●Alarm tone is output when there is an abnormality in the camera recorder. Alarm tone is also output when the SDHC card is full or when the battery is low.
●Alarm tone is not output during recording.
Note:
●Increasing the volume of the monitor too much may result in howling of the camera microphone.
When a stereo type earphone jack is connected, perform the following setting to output stereo sound.
1
2 Set [Main Menu]B[A/V Out]B[Audio Monitor] to AStereoB. (A Page 87)
Only audio from
Memo:
●You can set the volume of the alarm tone with [Alarm Level] in the [Main Menu]B[Others] menu. (AOffB/ALowB/ AMiddleB/AHighB) (A Page 87)
45