Specifications, Amplifier Section-CA-UXZ7MD | JVC 0802MWMMDWJEM

Specifications

Design and specifications are subject to change without notice.

Amplifier Section—CA-UXZ7MD

Output Power (IEC 268-3):	46 W (23 W + 23 W) at 4	Ω (MAX.)
	40 W (20 W + 20 W) at 4	Ω (10 % THD)
Audio input sensitivity/Impedance (at 1 kHz)
AUX/DVD:	400 mV/47 kΩ (at “LEVEL 1”)
	200 mV/47 kΩ (at “LEVEL 2”)
Speaker Terminals:	4 Ω – 16 Ω

Tuner

CD player

MD recorder

Cassette deck

General

Supplied accessories

Speaker Section—SP-UXZ7MD

FM tuning range:		87.50 MHz—108.00 MHz
AM tuning range:		531 kHz—1 710 kHz
CD Capacity:	1 CD
Dynamic range:	88 dB
Signal-to-noise ratio:	95 dB
Wow and flutter:	Immeasurable
Audio playing system:	MiniDisc digital audio system
Recording system:	Magneto-optical overwrite system
Reading system:	Non-contact, semiconductor laser pickup (λ=780 nm)
Error correction system:	CIRC (Cross Interleave Reed-Solomon Code)
Recording/Playback time (when using a 80-minute MD)
	SP:	80 minutes
	LP2:	160 minutes
	LP4:	320 minutes

Sampling frequency:	44.1 kHz
Audio compression system:
ATRAC (Adaptive TRansform Acoustic Coding)/ATRAC3 (					)
ATRAC (Adaptive TRansform Acoustic Coding)/ATRAC3 (					)
Frequency response:
Normal (type I): 60 Hz—14 000 Hz
Wow and flutter:	0.15 % (WRMS)
Power requirement:	AC 240 V , 50 Hz
Power consumption:	At operation:	65 W
	On standby:	13 W
		1.4 W (in power save mode)
Dimensions (approx.):	185 mm x 265 mm x 316 mm (W/H/D)
Mass (approx.):	5.9 kg

See “Unpacking” on page 6.

Type:	2-way bass-reflex type
Speakers:	Woofer 11 cm cone x1,
	Tweeter 4 cm cone x1
Power handling capacity:	35 W
Impedance:	4 Ω
Frequency range:	55 Hz to 20 kHz
Sound pressure level:	82 dB/W•m
Dimensions (approx.):	145 mm x 265 mm x 215 mm (W/H/D)
Mass (approx.):	2.2 kg each

US and foreign patents licensed from Dolby Laboratories.

– 70 –

Image 73

JVC 0802MWMMDWJEM, LVT0900-008A manual Specifications, Amplifier Section-CA-UXZ7MD

Contents

UX-Z7MD-Consists of CA-UXZ7MD and SP-UXZ7MD Micro Component MD SystemPage Class Laser Product Introduction Precautions Contents Main Unit Location of the ButtonsMain unit Display window Display window on the electronic swing panel Pressing one of these buttons also turns on the unit Remote Control Getting Started Connecting AntennasUnpacking FM antenna You can connect the speakers using the speaker cords Connecting SpeakersAM antenna To connect an outdoor AM antenna To remove the speaker grilles Connecting External EquipmentTo connect external equipment Speaker grilles are removable as illustrated below R6PSUM-3/AA15F Putting the Batteries into the Remote Control Basic and Common Operations Remote control Setting the Auto Power Off Turning On the PowerTurning On/Off the Key-touch Tone To turn off the clock indication power save mode Setting the ClockTo check the clock time with tones If Cannot Listen appears in the main display To increase the volume, turn Volume + / control ClockwiseFor private listening Sound indicator goes off from the display To check the sound mode currently selected, pressReinforcing the Bass Sound Selecting the Sound Modes To select the illumination color Setting the Display IlluminationTo create your favorite colors To change the display brightness Listening to FM and AM Broadcasts Remote control Main unit To change the FM reception mode Tuning in to a StationOn the remote control only Press FM Mode To stop during searching, press ¢or 4or UP or Tuning in to a Preset Station Presetting StationsPress the number buttons to select a preset number Press SET Playing Back CDs CD-R/CD-RW Playing Back the Entire CD-Normal Play Precautions on CD Playback Basic CD Operations To go to another track directly using the number buttonsProgram Play To stop playback for a moment Playing at Random-Random Play To check the program contentsRepeating Tracks-Repeat Play To modify the program Playing Back MDs To locate a particular point in a track during play Basic MD Operations While playing or pausing About MD indicatorOn the remote control only Load an MD Press MD 3/8, then On the main unit only To prohibit disc ejection Tracks of the loaded MD will play at random To erase the entire program, press MD 0 to eject the MDTracks are played at random To skip the playing track, press ¢ Press Group Skip or Group Skip to select a group Playing Tracks in a Group-Group PlayTo go to another track in the same group, press ¢ or To go to another group, press Group Skip Searching for Tracks to Play MD Title Search Playing Back Tapes Playing Back a Tape To play both sides-Reverse modeTo change the information shown in the main display Listening to External Equipment For how to apply sound effects, see Adjusting the Audio Input LevelListening to External Equipment Recording About the track marks Before You Start Recording on an MDTo avoid erasing important recordings To put a track mark manually while recording an Stereo Long-Hour Recording Mdlp Precautions for performing long-hour stereo recordingAbout High-Speed Recording To check the remaining recording time To set the recording length mode Setting MD Recording ModesTo set LP-prefix addition mode To set Group recording mode To record a single track during play or pause Recording Other Sources onto an MD Before You Start Recording on a Tape To clean the heads, capstans, and pinch rollersTo protect your recordings To keep the best recording and playback sound quality To record a single track of a CD/MD during play Recording onto a TapePrepare the source to record To record a disc To record an MD When recording on an MD and a tape at the same time Press REV.MODE to select the reverse modeFor the tape Press MD&TAPE REC Editing MDs How to make up Groups Using MD Group functionsGuidance-MD Group Functions Classifying the tracks on an MD Introducing Group Editing Functions Press SET During playback Forming a Group-FORM GRPress ¢or 4to select the first track of a new group Press ¢or 4to select the last track of the new group Adding a Track to a Group-ENTRY GR When Cannot ENTRY! appears in stepPress ¢or 4to select the track Or Group Skip To join the divided groups again, see the Join GR Dividing a Group-DIVIDE GRFunction on Joining Two Groups-JOIN GR When Cannot Join appears in stepTo divide the group again, see the Divide GR function Moving a Group-MOVE GR Ungrouping Tracks-UNGROUP To cancel the setting, press CancelDissolving All Groups-UNGR ALL Erasing Tracks in a Group-ERASE GR Introducing Track Editing Functions Dividing a Track-DIVIDE Press or to precisely adjust the dividing pointPress ¢or 4to select the track you want to divide To join the divided tracks again, see the Join function Joining Two Tracks-JOIN When the track belongs to a groupTo divide the joined tracks, see the Divide function on If Cannot Join appears in step Press ¢or 4to select the track you want to move Moving a Track-MOVE Erasing All Tracks-ALL Erase Erasing Tracks-ERASEPress SET Press ¢or 4to select the track you want to erase Assigning Titles to an MD Press or to change the title entry modeFor the group title For the disc and track title Repeat steps 5 1 and 5 2 to enter other characters Press Cancel to exit from the title entry modePress Enter to finish the current title entry For the disc title You can make a correction or change the title Changing the TitleMake sure that the character you want to change is flashing Using the Timers How Recording Timer actually works Using Recording Timer How Daily Timer actually works Using Daily TimerTo turn off the Recording Timer after its setting is done To turn on the Recording Timer again To turn on the Daily Timer again To turn off the Daily Timer after its setting is doneVolume setting appears in the main display If the unit is kept turned on when the timer-on time comes Timer Priority Using Sleep TimerHow Sleep Timer actually works Maintenance Additional Information Utoc User Table Of ContentsMD Disc Types Atrac Adaptive TRansform Acoustic Coding/ATRAC3 Scms Serial Copy Management System Symptoms CauseHcms High-speed Copy Management System MD limitations Cannot REC x1 REC only CD/MD MessagesCannot REC x1 or x2 only Message Symptom Troubleshooting Amplifier Section-CA-UXZ7MD Specifications Victor Company of JAPAN, Limited