JVC LYT0002-088B En Re Cor Din G, Recording From The Middle Of a Tape, Select Mode, Start Search

20EN RECORDING (Cont.)

Recording From The Middle Of A Tape

When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this procedure.

LCD monitor

STOP PLAY REW FF

PLAY/PAUSE REW FF

STOP

EC 5
R	S
OFF
Y
A
L

P		Lock button
		RECORDING
Power Dial		START/STOP Button
	S
C	5
E
R
OFF
	Y
	ALP

1 OPEN LCD MONITOR

Make sure the LCD monitor is open fully.

2 SELECT MODE

Press down the lock button located on the Power Dial and turn the Power Dial to "PLAY".

3 START SEARCH

Press PLAY/PAUSE, then press REW or FF. Watch in the LCD monitor for the spot where you want to begin recording.

4 ENGAGE STILL MODE

Once you find the spot at which you want to start recording, press PLAY/PAUSE to engage the Still mode.

5 START RECORDING

Set the Power Dial to “REC” and press

RECORDING START/STOP.

•Start recording from a point prior to the end of the last recording. A few seconds of the end of the last recording will be erased.

NOTE:

If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.