JVC LYT0002-088B manual Installing The Battery Pack, Open Battery Cover, Insert Battery

NOTES:

●If you connect the camcorder’s DC cord to the adapter during battery charging, power is supplied to the camcorder and charging stops.

●When using the AC Power Adapter/Charger, be sure to use the supplied power cord only.

●The AC Power Adapter/Charger is for use with the BN-V812U Battery Pack only.

●When charging the Battery Pack for the first time or after a long storage period, the Charge Indicator may not light. In this case, remove the Battery Pack from the AC Power Adapter/Charger, then try charging again.

●Since the AC Power Adapter/Charger processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

** Charging Environment

Perform charging where the temperature is between 10° and 30°C. (20°–25°C is the ideal temperature range for charging.) If the environment is too cold, charging may be incomplete.

Continuous Shooting

Continuous shooting is possible for approximately

60 minutes, under the following conditions:

•A BN-V812U Battery Pack is in use

•The temperature is approximately 20°C/68°F

However, . . .

•If the temperature is below 10°C/50°F, or

•If zoom or Record/Standby are engaged repeat- edly, continuous shooting capability is reduced significantly. Before extended use, it is recom- mended that you prepare enough battery packs to cover 3 times the planned shooting time.

EN 9

Installing The Battery Pack

The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has been charged fully.

Battery cover

Open switch

1

2

Battery

1 OPEN BATTERY COVER

1 Slide the open switch on the battery cover.

2 Pull open the battery cover in the direction of the arrow.

2 INSERT BATTERY

Insert the + – end of the battery first.

CLOSE BATTERY COVER
3 Slide the open switch and close the battery
cover.
BATTERY	RECORDING TIME
BN-V812U	approx. 60 min.

NOTES:

●To remove the battery pack, turn the Power Dial to "OFF", open the battery cover and slide the battery pack out.

●Be careful not to drop the battery pack.