EN69

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTES:

Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

To perform Insert Editing while watching in the television, make connections (pg. 56, 57)

6w

Remote sensor

TC 12 : 34

Lock button

 

 

P

 

 

L

 

 

A

 

 

Y

5S

M

AOFF

 

 

Power Dial

RM-V711U (provided)

START/STOP

T W

DISPLAY

INSERT

PLAY

PAUSE

REW(IND)

1 FIND EDIT OUT POINT

Playback the tape to locate the point where you want to stop editing. Confirm the time code at this point (pg. 55).

2 FIND EDIT IN POINT

Press REW until the point is located, then press

PAUSE.

3 PREPARE FOR INSERT EDITING Press and hold INSERT on the remote control, then press PAUSE. “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 START RECORDING

Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

5 PAUSE DURING EDITING

Press START/STOP. The camcorder re-enters Insert Pause mode. Press again to resume editing.

6 STOP EDITING

Press STOP while the camcorder is in the Insert-Pause mode.

NOTES:

P.AE/Effects (pg. 42) can be used to spice up the scenes being edited during Insert Editing.

To display the Time Code during Insert Editing, (pg. 54).

When performing Insert Editing, the tape’s Video Area and Sub-Code Area (pg. 6) are rewritten, so the date and time information changes.

If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops and “ERROR! REFER MANUAL” appears.

Page 69
Image 69
JVC LYT0216-001B specifications Insert Editing, Find Edit OUT Point, Find Edit in Point, Pause During Editing