JVC LYT0242-001A manual 18ENRECORDING, BasicFeaturescont, NOTE Recording From The Middle Of A Tape

Models: LYT0242-001A

1 72
Download 72 pages 58.27 Kb
Page 18
Image 18
18ENRECORDING

18BasicFeatures(cont.)NOTE: Recording From The Middle Of A TapeTime CodeENRecording From The Middle Of A TapeWhen blank portion is recorded on a tapeProper recordingManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundRECORDINGManual backgroundManual background

BasicManual backgroundManual backgroundFeaturesManual backgroundManual background(cont.)Manual backgroundManual backgroundManual background

NOTE: Recording From The Middle Of A Tape

Time Code

During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.

If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number.

To perform Random Assemble Editing (pg. 48 – 53), time code is necessary. If during recording a blank portion is recorded partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent leaving a blank portion on a tape, perform the procedure in “Recording From The Middle of A Tape” (see below) in the following cases;

After playing back the recorded tape, when you shoot again.

When power shuts off during shooting.

When a tape is removed and re-inserted during shooting.

When shooting using a partially recorded tape.

When shooting on a blank portion located partway through the tape.

When shooting again after already shooting a scene and opening/closing the cassette cover.

Display

TC 12 : 34 : 24

Time code is displayed during playback.

Minutes

Seconds

Frames

(25 frames = 1 second)

Recording From The Middle Of A Tape

1.Play back a tape to find the spot at which you want to start recording, then engage the Still Playback mode (pg. 37).

2.Set the Power Switch to “CAMERA” (“AUTO” or “PRO.”) and start recording.

NOTES:

The Time Code cannot be reset.

During fast-forwarding and rewinding, time code indication does not move smoothly.

When blank portion is recorded on a tape

Time code

Time code

Time code

00:00:00

05:43:21

00:00:00

Tape

Already recorded scene

Blank

Newly recorded scene

Shooting start point Shooting stop point Shooting start point

Proper recording

Time code

Time code

Time code

00:00:00

05:43:21

05:44:00

Tape

Already recorded scene

New scene

Latest scene

Shooting start point

Shooting start point

Shooting start point

Page 18
Image 18
JVC LYT0242-001A 18ENRECORDING, BasicFeaturescont, NOTE Recording From The Middle Of A Tape, Time Code, Proper recording