50EN
USINGTHEREMOTECONTROLUNIT(cont.)
Programme
|
|
|
|
|
|
|
| IN | OUT MODE |
| 1 | – – – |
| |
| 2 |
|
|
3~
4~
5~
6~
7~
8~
TIME CODE | – |
TOTAL | 0 0 : 0 0 |
Random Assemble Editing Menu
Power Switch
SELECT SCENES (cont.)
6
7
8 USE FADE/WIPE ON SCENE TRANSITION (IF NECESSARY)
Press FADE/WIPE.
Remote sensor
(provided) | T | W |
|
| |
|
| PLAY |
FADE/WIPE |
| EFFECT |
|
| |
EDIT IN/OUT |
| R.A.EDIT |
|
| ON/OFF |
|
| CANCEL |
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•If you select a Fade/Wipe effect for an
•You cannot use a Picture Wipe/Dissolve at the end of the last scene.
•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).
9 USE PROGRAMME AE WITH SPECIAL EFFECTS (IF NECESSARY)
Press EFFECT.
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•You can use Classic Film, Monotone, Sepia or Strobe mode.
10 REGISTER ADDITIONAL SCENES Repeat steps 6 through 9.
•To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.
•If you are not using Fade/Wipe or Programme AE with special effects, repeat steps 6 and 7 only.
NOTES:
●When the source tape has more than 2 identical time codes (☞ pg. 18), the camcorder may not find the
●When choosing a scene, set
●If the search time for an
●If there are blank portions before or after the
●Since time codes register time only as accurately as seconds, the time code total time may not match the total programme time exactly.
●Turning off the camcorder’s power erases all registered
●If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next