EN 33
NOTES:
●After dubbing, set “S/AV INPUT” back to “OFF”.
●Analogue signals can be converted to digital signals with this procedure.
●It is also possible to dub from another player.
●Depending on the tape source input, images may appear with horizontal jitter on the player’s LCD monitor during dubbing. This does not affect the actual recording.
Dubbing To Or From A Video Unit Equipped With An i.LINK Connector (Digital Dubbing)
Using an i.LINK cable (optional), it is possible to dub recorded scenes in DV format from the player onto another video unit equipped with i.LINK connector. Since a digital signal is sent, there is little if any image or sound deterioration.
Images recorded in SD or HD mode can be dubbed only to a
DV MPEG2
| i.LINK Output |
I.LINK OUT | Select Switch |
|
To i.LINK Connector
i.LINK cable (optional)
To i.LINK IN/OUT
Video unit equipped with i.LINK connector
NOTES:
●It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack. ( pg. 10)
●When using an i.LINK cable, be sure to use the optional JVC
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●It is possible to dub in MPEG2 format from a
To use this player as a player
1Make sure all units are turned off.
2Connect this player to a video unit equipped with an i.LINK input connector using an i.LINK cable as shown in the illustration.
3Set this player’s Playback Mode Switch to “VIDEO”.
4Set “i.LINK OUT” to “SW”. ( pg. 26, 28)
●If, in future, the connected video unit automatically detects the DV and MPEG2 formats, set “i.LINK OUT” to “AUTO”. In this case, proceed to step 6.
5Set the i.LINK Output Select Switch on this player to “DV” to output scenes recorded in DV mode, or “MPEG2” to output scenes recorded in HD or SD mode.
6Turn on the video unit’s power.
7Insert the source cassette in this player.
8Insert the recording cassette in the video unit.
9Press 4/9 on this player to start playback of the source cassette.
10At the point you want to start dubbing, engage the video unit’s Record mode.
11To pause dubbing, engage the video unit’s
12Repeat steps 10 – 11 for additional editing. Stop the video unit and player.
NOTES:
●If a blank portion or disturbed image is played back on the player during dubbing, unusual images may be dubbed or the dubbing may stop.
●If a scene which has been paused during recording is dubbed to other devices, playback may stop at the point.
●Do not connect the player through a hub.
ADVANCED FEATURES
