| VIDEO RECORDING EN 17 | |
Basic Recording | NOTES: | |
| ● If the | |
NOTE: | camcorder’s power shuts off automatically. To turn the | |
camcorder on again, push back and pull out the viewfinder | ||
Before continuing, perform the procedures listed below: | again or close and | |
● Power ( pg. 12) | ||
● When a blank portion is left between recorded scenes on | ||
● Loading A Cassette ( pg. 15) | ||
the tape, the time code is interrupted and errors may occur | ||
| ||
POWER/CHARGE Lamp | when editing the tape. To avoid this, refer to “Recording | |
From The Middle Of A Tape” ( pg. 19). | ||
| ||
Lock Button | ● To turn the tally lamp or beep sounds off, pg. 29, 31. | |
● During recording, sound is not heard from the speaker. To | ||
| hear the sound, connect optional headphone to the | |
| headphone connector. Adjust the sound volume by sliding | |
Power Switch | the Power Zoom Lever VOL. | |
Tally Lamp | Tape Remaining Time | |
Approximate tape remaining time | ||
(Lights while recording is in | ||
progress.) | appears on the display. “– h – – m” | |
VIDEO/MEMORY | means the camcorder is calculating | |
the remaining time. When the | ||
| remaining time reaches 2 minutes, | |
Power Zoom Lever | the indication starts blinking. | |
● The time required to calculate and display the remaining | ||
| ||
Recording Start/Stop Button | tape length, and the accuracy of the calculation, may vary | |
according to the type of tape used. |
LCD Monitor And Viewfinder
RECORDING & PLAYBACK
1 Remove the lens cap. ( pg. 10)
2 Open the LCD monitor fully.
3 Set the VIDEO/MEMORY Switch to “VIDEO”.
4 Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.
●The POWER/CHARGE lamp lights and the camcorder enters the
●To record in LP (Long Play) mode, pg. 29.
5 To start recording, press the Recording Start/Stop Button. The tally lamp lights and “T REC” appears on the display while recording is in progress.
6 To stop recording, press the Recording Start/Stop Button again. The camcorder
Approximate recording time
Tape |
| Recording mode | |
|
|
| |
| SP |
| LP |
|
|
|
|
30 min. | 30 min. |
| 45 min. |
|
|
|
|
60 min. | 60 min. |
| 90 min. |
|
|
|
|
80 min. | 80 min. |
| 120 min. |
|
|
|
|
While using the LCD monitor:
Make sure the viewfinder is pushed back in. Pull on the end a of the LCD monitor and open the LCD monitor fully. It can rotate 270° (90° downward, 180° upward).
While using the viewfinder:
Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.
180˚
NOTES:
●The image will not appear simultaneously on the LCD monitor and the viewfinder except during Interface Shooting. ( pg. 18) When the viewfinder is pulled out while the LCD monitor is opened, you can select which one to use. Set “PRIORITY” to the desired mode in SYSTEM Menu. ( pg. 29, 31)
●Coloured bright spots may appear all over the LCD monitor or the viewfinder. However, this is not a malfunction.
( pg. 49)
VIDEO
