Common Operations
Continued
Turning On or Off the Power
3 Turn 4/ ¢to adjust the minute, then press SET.
STANDBY/ON 
so that the STANDBY lamp goes off.
STANDBY/ON 
again so that the STANDBY lamp lights up.
STANDBY/ON
STANDBY
STANDBY/ON
STANDBY
To check the clock time
Press and hold SET while playing any source.
• Pressing SET, the source indication appears again.
To adjust the clock again
•A little power is always consumed even while the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from a wall outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “AM 12:00” right away, while the tuner preset stations (see page 13) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.
On the unit ONLY:
1 Press CLOCK/TIMER.
The hour digits start flashing on the display.
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.
•Each time you press the button, the clock/timer setting modes change as follows:
DAILY 
ON TIME 
REC
(Daily timer setting)
Canceled |
| Clock |
| ON TIME |
|
| |||
|
| setting |
| (Recording |
| (The hour digits | timer setting) | ||
| start flashing.) |
| ||
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “AM 12:00” right away. If this happens, set the clock again.
Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM.(See page 13.)
To playback discs, press DVD 3´8 (or DVD 3on the remote control). (See pages 14 – 26.)
To playback tapes, press TAPE 2 3. (See page 27.)
To select the external equipment as the source, press AUX.
2 Turn 4/ ¢to adjust the hour, then press SET.
The minute digits start flashing on the display.
•If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.
When you press the play button for a particular source (FM/AM, DVD 3/8(or DVD 3on the remote control), TAPE 2 3, and AUX), the unit turns on (and the unit starts playing the source if it is ready).
