•The new value is stored on the PC.

52EN ADVANCEDOPERATIONS(cont.)

Adjusting the gap between stored In/Out points on the PC and dubbed ones on the recorder

During dubbing, the beginning of the scene stored on the PC may be missed, or the scene prior to the transition you chose for the In/Out points may be dubbed onto the recorder. When this occurs, adjust the gap for more accurate editing.

1 After dubbing (see page 43), play back the dubbed scene to check the In/Out point timing.

2 Select Preferences — Options on the JLIP Video Producer Window to bring up the Options dialog box.

3 To set the In point or Out point, enter the numeric value or click ¶ƒ.

To adjust the In point timing, enter a new value from 0 Frame to –200 Frame.

In point

: when the scene starts too

 

early, enter a smaller value

 

than the present value.

In point

: when the scene starts too

 

late, enter a larger value

 

than the present value.

•The default setting is –33 Frame. •Click Default to return settings to

factory defaults.

To adjust the Out point timing, enter a new value from 0 Frame to –200 Frame. Out point : when the scene ends too

late, enter a larger value than the present value.

Out point : when the scene ends too early, enter a smaller value than the present value.

•The default setting is –8 Frame. •Click Default to return settings to

factory defaults.

4 Click OK.

5 To check the corrected In/Out point timing, dub the stored scenes and play them back.

NOTE:

Even if the In/Out point timing is adjusted, there may still be a slight margin between adjusted In/Out points and those of the dubbed scenes.