GENERAL
WARNING MESSAGES
To prevent operational errors, the LCD display shows one of the following warning messages when an erroneous operation is performed.
Displayed Message | Cause | Check Point |
|
|
|
INVALID ENTRY | The gain is set to the LoLux mode. | Exit from the LoLux mode, and then |
GAIN : LOLUX |
| adjust the gain again. |
|
|
|
INVALID ENTRY | The FULL AUTO button is ON. | Press the FULL AUTO button so that |
FULL AUTO : ON |
| the lamp in it turns off, then retry |
|
| operation. |
|
|
|
INVALID ENTRY | ACC+EEI is ON. | Exit from the ACC+EEI mode, and then |
GAIN : ALC + EEI |
| retry operation. |
|
|
|
INVALID ENTRY | The | Cancel FAW and start the |
W.BAL : FAW | mode. | adjustment. |
|
|
|
INVALID ENTRY | The W.BAL button is set to PRESET. | Auto white balance adjustment cannot |
W.BAL : PRESET |
| be started in this mode. |
|
|
|
INVALID ENTRY | The white balance adjustment is set to | Auto white balance adjustment cannot |
W.BAL : MANUAL | manual mode by the AUTO/MANU button. | be started in this mode. |
|
|
|
INVALID ENTRY | The BARS button is pressed. | Press the BARS button so that the |
BARS : ON |
| lamp in it turns off, then retry operation. |
|
|
|
ERROR MESSAGES
When the LCD display shows one of the following error messages during an auto white balance adjustment and AUTO SET mode, check “Cause” and “Check Point” below and then retry the auto white balance adjustment. (The error message is displayed for about 5 seconds.)
Displayed Message | Cause | Check Point |
|
|
|
AUTO WHITE A (B) | The light intensity is insufficient. | Increase the lighting (illumination) or |
ERROR: LOW LIGHT |
| boost the gain with the GAIN button. |
|
| (Note that the sensitivity deteriorates |
|
| when the gain is boosted.) |
|
|
|
AUTO WHITE A (B) | The object is not suitable for shooting. | Check if the object is white and change |
NG: OBJECT |
| the object if required. |
|
|
|
AUTO WHITE A (B) | ● The amount of incident light is too high. | ● Check if a strong light source, such as |
ERROR: OVER LIGHT |
| the sun, is shining into the camera ei- |
|
| ther directly or as a result of a reflec- |
|
| tion caused by the object. |
| ● The color temperature conversion fil- | ● Set the color temperature conversion |
| ter is not set properly. | filter to the correct position. |
|
|
|
AUTO BLACK LENS NOT CLOSED? | The lens will not close for auto | Set the camera so that the lens can be |
| ance adjustment. | closed. |
|
|
|
AUTO BLACK ERROR! | Auto black adjustment is not working | Check the setups of the |
| properly. | camera again. |
|
|
|
28
