Brother HL-1260E manual Error Messages, Buffer Error, Memory Full, Line Error, Print Check

		CHAPTER 7 TROUBLESHOOTING
Error Messages
Error Message	Meaning	Action
31 PRINT OVERRUN	Print overrun	Press the CONTINUE switch
		to start printing the next page.
		Data which overran the print
		area on the page cannot be
		printed. Check your page
		protection setting with the
		MODE switch. Setting page
		protection to the correct size
		could solve this problem. If
		printing at 600 dpi, you may
		need to add optional SIMM
		memory. See page 5-7.
32 BUFFER ERROR	Input buffer overflow	Press the CONTINUE switch
		to resume printing. Data lost in
		overflow cannot be printed.
		See page 4-46.
34 MEMORY FULL	Work memory overflow	Press the CONTINUE switch
		to resume printing. If the same
		error should occur after you
		press the CONTINUE switch,
		turn off the printer. Wait a few
		seconds, then turn it on again.
		Reduce the input buffer size.
		See page 4-46.Turn off
		“KEE P PCL.” Add SIMM
		memory with power off.
		Download font and the fonts
		saved in the HDD card might
		cause the error, for it occupies
		the same work area as the
		RAM. Memory expansion is
		recommended in that case. See
		page 5-7.

40 LINE ERROR

Error in the communications	When the serial interface is
circuit	used, check the
	communications parameters
	such as baud rate, code type,
	parity, and handshake
	protocols. When the parallel
	interface is used, check the
	interface cable connection.

41 PRINT CHECK	Error in communication with	Turn off the printer. Wait a few
	the engine controller	seconds, then turn it on again.

7–3