USER’S GUIDE

Display Message

Graphics Mode

PEN SETTING

Set the size and percentage of gray

 

separately for six plotter pens.

 

 

CHARACTER SET

Set the standard and alternate character sets.

Note

In most cases, the application software controls the above graphics mode settings, so you do not need to set them in this menu with the MODE switch. The software or command setting overrides the switch setting.

Select the setting menu and enter the sub-setting menu to make the settings as follows:

Pen Setting

When you select “PEN SETTING,” you can set the size and percentage of gray for each plotter pen. You can make settings separately for six pens.

Select the pen with the or switch and enter the menu with the SET switch.

SETTING=PEN1

After you select the pen, advance to the sub-setting menu for size or gray- percentage selection with the or switch and enter the menu with the SET switch.

When the following message appears, the pen size can be set from 1 dot to

10 dots with the or switch:

SIZE 1=3 dots *

When the following message appears, the shades of gray can be set to 15, 30, 45, 75, 90, or 100% with the or switch.

GRAY 1=100%

*

 

 

4–26

Page 93
Image 93
Brother HL-1260E manual PEN Setting, Character SET, SETTING=PEN1, Size 1=3 dots, Gray 1=100%