CHAPTER 4 CONTROL PANEL
2.Press the SET switch to enter the media type mode. The display then shows the current setting with an asterisk:
REGULAR *
3.Press the ▲ or ▼ switch to select regular, thick paper, or transparency.
4.Press the SET switch to make the setting effective.
✒Notes
∙Please do not forget to change the setting back after you print your special media with the setting changed.
∙Envelopes cannot be fed from Tray 2 although you can set them in it.
∙You must not load transparencies into Tray 1 or Tray 2. Please use the
DUPLEX MODE
If the optional duplex printing unit has been installed, the duplex mode appears on the display as follows:
DUPLEX MODE
1.Press the SET switch to enter the duplex mode menu.
Then the display shows the current selection for the duplex printing or simplex printing (duplex off) with an asterisk as follows:
DUPLEX=OFF *
2.Press the ▲ or ▼ switch to select the duplex or simplex (duplex off), and press the SET switch.
When you set “DUPLEX=ON”, the display shows the current bind setting with an asterisk as follows:
BIND=LONG *
3.Press the ▲ or ▼ switch to select long edge binding or short edge binding.
