One Touch Operation
This receiver can memorize the optimum sound settings for each playing source.
About the One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
Notes:
• If the source is TUNER/BAND, |
the One Touch Operation |
function memorizes the settings |
each for the FM and AM band. |
The following can be stored for each source:
•Volume level (see page 15)
•Balance (see page 17)
•Loudness (see page 17)
•Preset SEA modes (see page 24)
•
•DAP mode settings (see page 29)
•Surround mode settings (see page 37)
Using the One Touch Operation
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled and appear on the display in turn.
2.Adjust the sound using the functions listed above. The newly adjusted settings are memorized.
ONE TOUCH OPERATION
• |
and surround mode cannot be |
used at the same time. |
To recall the sound settings |
|
With the ONE TOUCH OPERATION lamp lit, the settings | ONE TOUCH |
for the currently selected source is recalled, and appears on | OPERATION |
| |
the display when the source is selected. |
|
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off.
(Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)
20
