Setting the idle timeout
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight I/O.
5.Press 
to select I/O.
6.Press 
to highlight EIO X (where X = 1, 2, or 3).
7.Press 
to select EIO X.
8.Press 
to highlight TCP/IP.
9.Press 
to select CONFIG METHOD.
10.Press 
to select CONFIG METHOD.
11.Press 
to highlight MANUAL.
12.Press 
to select MANUAL.
13.Press 
to highlight MANUAL SETTINGS.
14.Press 
to select MANUAL SETTINGS.
15.Press 
to highlight IDLE TIMEOUT.
16.Press 
to select IDLE TIMEOUT.
17.Press the 
or 
arrow to to increase or decrease the number of seconds for the idle timeout.
18.Press 
to save the idle timeout.
19.Press the PAUSE/RESUME button to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a specific speed:
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight I/O SUBMENU.
5.Press 
to select I/O SUBMENU.
6.Press 
to highlight EIO X (where X = 1, 2, or 3).
7.Press 
to select EIO X.
8.Press 
to highlight LINK SPEED.
9.Press 
to select LINK SPEED.
10.Press 
to highlight the desired link speed.
11.Press 
to select the desired link speed.
12.Press the PAUSE/RESUME button to return to the Ready state.
50 Chapter 3 I/O Configuration | ENWW |