Note
Note
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, default gateway, syslog server, and idle timeout.
Setting an IP address
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight I/O.
5.Press 
to select I/O.
6.Press 
to highlight EIO X (where X = 1, 2, or 3).
7.Press 
to select EIO X.
8.Press 
to highlight TCP/IP.
9.Press 
to select CONFIG METHOD.
10.Press 
to select CONFIG METHOD.
11.Press 
to highlight MANUAL.
12.Press 
to select MANUAL.
13.Press 
to highlight MANUAL SETTINGS.
14.Press 
to select MANUAL SETTINGS.
15.Press 
to highlight IP ADDRESS.
16.Press 
to select IP ADDRESS.
The first of four sets of numbers is highlighted. Each set of numbers represents one byte of information and has a range from 0 to 255.
17.Press the 
or 
arrow to increase or decrease the number for the first byte of the IP address.
To cycle through the numbers faster, hold down the arrow button.
18.Press 
to move to the next set of numbers. (Press 
to move to the previous set of numbers.)
19.Repeat steps 16 and 17 until the correct IP address is entered.
20.Press 
to save the setting.
21.Press the PAUSE/RESUME button to return to the Ready state.
Setting the subnet mask
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight I/O.
5.Press 
to select I/O.
ENWW | Network configuration 47 |