Auto continue
You can determine printer behavior when the system generates an Auto Continuable error. ON is the default setting.
●ON displays an error message for ten seconds before automatically continuing to print.
●OFF pauses printing any time the printer displays an error message and until you press 
.
To set the auto continue
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight SYSTEM SETUP.
5.Press 
to select SYSTEM SETUP.
6.Press 
to highlight AUTO CONTINUE.
7.Press 
to select AUTO CONTINUE.
8.Press 
or 
to select the appropriate setting.
9.Press 
to set the selection.
10.Press PAUSE/RESUME.
Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default value.
●CONTINUE allows the printer to continue printing while displaying a warning until the supply is replaced.
●STOP causes the printer to pause printing until you replace the used supply or press 
, which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1.Press 
to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight SYSTEM SETUP.
5.Press 
to select SYSTEM SETUP.
6.Press 
to highlight SUPPLIES LOW.
7.Press 
to select SUPPLIES LOW.
8.Press 
or 
to select the appropriate setting.
9.Press 
to set the selection.
10.Press PAUSE/RESUME.
ENWW | Changing printer control panel configuration settings | 41 |